Send audio output to audio devices

New documents created with mimoLive automatically add an Audio Aux Output Destination, named Audio Monitor, that allows you to route audio mixes to a specific audio output device. You can add additional Audio Aux Output Destinations to route any desired audio mix to the same audio output device using a different channel selection or to other audio output devices.

Adding an Audio Aux Output Destination

Add a new Audio Aux Output Destination to your Output Destinations list by clicking the + button on top of the list in the right most column of your mimoLive document. A popover window will appear with all the Output Destination options available. After double clicking the Audio Aux Output Destination icon a new instance will appear in the Output Destination list.

Setting up the Audio Aux Output Destination

The Start with show and Stop with show options control if the Output Destination should start and stop together with the Start/Stop Show Button. Just remember that the Output Destination may always be activated and deactivated manually by clicking its activation button.

You can select a specific Audio Mix that will be output by the Output Destination. Please refer to Audio Mix Panel to learn more about setting up audio mixes.

Clicking the action button to the right of the Audio Mix menu popup button reveals a context menu that lets you open the Audio Mix Panel or rename and remove audio mixes.

The lower section of the settings view lets you select an audio output device from the list of available devices on your system, set the Output Destination’s output volume and select the physical output channels where the selected audio mix’s left and right channel should be played out.

1. mimoLive: Audio Mix layer volumes and master volume
2. mimoLive: Audio Aux Output Destination volume
3. macOS: Audio Device master volume (check Audio-MIDI-Setup, for instance)
4. Physical device: Driver output volume (matrix, mixer) and physical output volume (knob)

Channel Selection

An Audio Aux Output Destination always allows the selection of any available channel of a device. However, in case a particular device is currently live in another Output Destination with one or more of the selected channels the Audio Aux Output Destination will not be allowed to start. In this case the activation button will become gray and the selected device will read (busy) or (channel selection unavailable) until the device and channel selection was changed or the other Output Destination stops.

While downmixing different Audio Aux Output Destinations to the same physical device channels is not allowed, downmixing both output channels of one particular Audio Aux Output Destination to the same physical device channel can easily be achieved by selecting the same device channel for both the Left Channel and the Right Channel. Unsurprisingly this configuration performs the standard mono summing “M = 0.5 * L + 0.5 * R” to avoid clipping.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment