This mimoLive tutorial will explain how to configure the build-in Call-In Show template in mimoLive.
Prerequisite
Your guests will call in via mimoCall using their browser. Ideally, they should have a headset and a camera.
Creating a new Document from the Call In Show Template
- Launch mimoLive. The New Document window will open up and let you select either a Template or choose from recently opened documents. If you don’t see the New Document window please choose “mimoLive > New…” in the main menu.
- Find the “Call In Show” template in the list of templates and select it. A sheet will open up at the bottom of the New Document window showing additional options.
- You need to specify the frame rate and the dimensions you want the video to be. It’s reasonable to go with 30fps and a 720p dimension.
- Click on the “Create New Document” button in the lower right corner. A new mimoLive document window will open up with lots of pre-configured layers.
Configuring the New Call-In Show Document
In order to make the document work you need to set up some things:
- Find the “mimoCaller A” and “B” in the Source Repository on the left. Make sure that they are active and after a couple of seconds their status below the source name label should read “Waiting for Partner”. If it doesn’t it probably is because you didn’t login into your Boinx Connect Account as described in the Prerequisite section.
- To invite the guests you need to click the “Copy Invitation Link” button. This will put a web URL to the macOS Paste Board for you to pass it on by a medium of your choice (email, WhatsApp, etc.). The “Share Invitation Link” button will let you share the link via macOS sharing services.
- Once a guest will open the link with a supported web browser they will appear in your show.
- Select the “Split Screen” layer in the Layer Stack. The Layer Settings panel right next to it will show all parameters for this layer.
- Enter the names of the host and the guests in the text fields “Content > Source Name A, B, and C”
- Find the Live Streaming Output Destination on the far right.
- Setup a Streaming Destination like your Facebook Timeline or your YouTube channel. Please refer to Live Streaming for details. Make sure that the Live button is green.
- Find the Audio Monitor Output Destination below the Live Streaming Setup.
- Select the audio hardware where you want to hear the guest’s audio. Consider using headphones as this helps to reduce echo and echo cancellation noises.
- Please note that the Audio Monitor Output Destination is set up that way that you won’t hear yourself as this echo confuses most people. This is done by a special Audio Mix that has a mix-minus with the host audio. You can check this Audio Mix in the Audio Mix Panel accessible through the Windows menu. As you can see the Main Camera audio is muted:
Streaming a Call-In Show
Now everything should be set up for your first Call-In Show to be streamed to the internet.
- Click on the Remote Control Surface Button on the left side of the document info box on top of the mimoLive window. This will open a browser window with the Remote Control Surface already configured for this template.
- On this remote control surface you can see all 3 video sources and “Solo” buttons to make each of them displayed in fullscreen mode if a guest is speaking for a longer time.
- Put the host (yourself) on “Solo” so you can begin with an introduction.
- Once everything and everyone is ready click on the “Start Show” button on the Remote Control surface. Check if the Live Streaming Output destination in the mimoLive document window is actually streaming.
- After your introduction you can “un-solo” yourself to reveal the other guests on the panel.
- If a guest talks about a topic for a longer time you can put them full screen with the Solo button below their preview.
- Once your show is over you need to click the “Stop Show” button in the Remote Control or on top of the mimoLive document window.
Post your comment on this topic.